Point light source one drag four, four channel UV LED curing

1. Low cost use: as photoelectric conversion efficiency, energy consumption is greatly reduced, and heat is not obvious. It is much better than the traditional gas UV light source with filter wavelength output.

 

 

 

 

2. Four channel UV LED curing machine power: 10W, long mechanical life of LED

 

 

 

 

4. The LED chip is directly close to the surface and does not need to use UV optical fiber for transmission, so the light source has high flexibility and utilization.

 

 

 

 

5. Whole small size: far smaller than various gas UV light sources, suitable for various applications.

 

 

 

 

6. If the current of the oil lamp is too high, the surface of the lamp will be dirty or splashed

 

 

 

 

7. Virtual connection, short circuit and large light flow of UV curing equipment make transformer overload operation measurement

 

 

 

 

8. Power supply voltage does not match replacement lamp, electric lamp, transformer and ballast

 

 

 

 

9. Pay attention to the cleanness of the lamp surface, the lamp brightness is too high, and the transformer is matched

 

 

 

 

10. Action of thermal protection switch caused by transformer overheating; solution: check the cause of transformer overheating and deal with it;

 

 

 

 

11. Low power supply voltage or power shortage; solution: increase voltage, configure voltage regulator, check circuit and switch, and reconnect;

 

 

 

 

12. Four channel UV LED curing machine is fast curing, reaction can be controlled, solvent-free and pollution-free, suitable for automatic operation;